Nextivity Q34-2/5/1366CUEXA

The Cel-Fi’s QUATRA networked smart booster applies Cel-Fi smart signal booster technology to applications within larger venues by allowing up to four (4) CUs to operate with a single NU. By synchronizing the outputs from multiple CUs, the coverage areas of each CU are stitched together to form one large cell that can cover an entire building, up to 50,000 sq-ft. per system. Cel-Fi QUATRA may use either an (a) off-air or (b) small…The Cel-Fi’s QUATRA networked smart booster applies Cel-Fi smart signal booster technology to applications within larger venues by allowing up to four (4) CUs to operate with a single NU. By synchronizing the outputs from multiple CUs, the coverage areas of each CU are stitched together to form one large cell that can cover an entire building, up to 50,000 sq-ft. per system. Cel-Fi QUATRA may use either an (a) off-air or (b) small cell donor input, depending on the specific coverage and capacity needs at the site. Once the system is mounted appropriately, standard CAT 5e (or better) cable is used to connect the NU with each CU. When powered-on, all network and system optimizations are performed automatically.This is a consumer device.Before use, you must register this device with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You must operate this device with approved antennas and cables as specified by the manufacturer. Antennas must be installed at least 20 cm (8 in) from any person.You must cease operating this device immediately if requested by the FCC or a licensed wireless service provider.Warning. E911 location information may not be provided or may be inaccurate for calls served by using this device. When used with any mobile device utilizing the 1710 – 1755 MHz band, the FCC limits booster equipment placement to a maximum of 10 meters above ground level. Installation of this equipment which does not comply with federal requirements may subject the owner to FCC enforcement action. Read More